High Performance, Non-Phthalate (NP), Low Bleed (LB)
plastisol formulated for Ultra high speed wet-on-wet automatic printing. The
New Atlas ink line is formulated using International Coatings 7500 series ink.
It is creamy and short bodied ink with low tack that is easy to print. It is
well suited for fine detail and halftone printing using finer mesh counts. The
7500 Series can achieve faster production speeds with less pressure and it is
extremely resistant to ink build-up.
Please Note: This ink has been reformulated using the International Coatings
7500 Series Line. Color shifts may occur if switching from our previous ink
line.
Recommended Fabrics:
100% cotton, cotton/polyester blends, polyester. Use an underbase for dark
fabrics.
Ink Application:
Colors should be printed without any modifications. If thinning is required,
use 1099 LB Lo-Bleed Reducer (1% to 5% by weight).
Screen Mesh:
110 to 305 Monofilament.
Emulsion:
Any direct or indirect plastisol emulsion. Use 35 to 70 micron capillary film
for best results.
Squeegee:
60-70 Durometer: Sharp Edge. 60/90/60 or 70/90/70 Triple Durometer: Sharp Edge
Drying Temperatures:
325º (163º C) Entire ink film. Test dryer temperatures and wash test printed
product before and during a production run.
Clean Up:
Any Environmentally friendly plastisol screen wash.
Storage of Ink Containers:
Keep indoors and store in a cool area. Recommended storage at 65º F to 90º F
(18º C to 32º C). Avoid storage in direct sunlight or in extreme temperature
conditions.