6100 Super Opaque Series Direct Print Plastisol Inks come in 18 colors and contain a high loading of pigments for maximum coverage on dark garments, thus eliminating the
need for under-basing.
The 6100 Series can also be printed on light colored garments at higher mesh countsor reduced to obtain soft-hand, opaque prints.
The 6100 Series is well suited for automated equipment although excellent results
can be achieved in almost any printing operation.
- Cure (325°F)
- Non-Phthalate
- Low Tack
- Can be printed wet-on-wet
Technical Data Sheet (Printable Version)
Recommended Fabrics:
100% cotton and 50/50 cotton/polyester blends. Use an underbase for dark fabrics. To achieve a softer soft and faster production speeds, print underbase through finer mesh counts (160-230 t/in).
Ink Application:
6100 Series colors should be printed without any modifications. If thinning is required, use 1099 Low Bleed Curable Reducer (1% to 3% by weight)
*Adding too much reducer or other additives to the 6100 Series inks may cause curing/fusing or increased dye migration problems
Screen Mesh: 61 to 230 t/in
Emulsion:
Any direct or indirect plastisol emulsion. For capillary film, use 35 to 70 micron for best results.
Squeegee: 60-70 Durometer, Sharp Edge
Cure Temperature:
325°F entire ink film
*It is always recommended to test dryer temperatures and wash test the printed product before and during a production run.
Clean Up: Any eco-friendly plastisol screen wash.
Storage of Ink Containers:
Keep indoors and store in a cool area. Recommended storage at 65º F to
90º F (18º C to 32º C). Avoid storage in direct sunlight or in extreme
temperature conditions.
Technical Data Sheet (Printable Version)