Direct Print Plastisol Ink
XOLB “Xtra Opaque Low Bleed” inks are high opacity multi-purpose
inks that are designed to produce extremely opaque prints yet are very
easy to print on a manual press. The smooth creamy consistency leaves a
uniform print for under-basing and can be opaque on black without a
white base with screens as fine as 160 mesh. XOLB inks are fast flashing, cure with a non-tack surface, and contain clean bright pigments.
100% cotton or cotton/polyester blends. Always test print fabric before beginning production
The XOLB series inks can be printed right out of the containers without any modifications.
80 to 305
Any direct emulsion or capillary film.
Gel/ Flash Cure:
Flash 2-3 seconds with the ink reaching 150-250F. To gel, ink should not
exceed 250F. Always complete a test print before doing a production
Transfer at 350F with a transfer adhesive. Cold peel.
Mineral spirits or any environmentally friendly plastisol screen wash.
Recommended storage temperature is 65-90 F (18-32 C). Avoid storing in direct sunlight and moist humid air.
P-5011 Curable Reducer: Use if thinning is required