A. CHECK THE FLASHBACK COMMUNICATOR BRACKET LOCATED ON THE BASE OF THE PRESS WHERE YOUR FLASHBACK CABLE IS PLUGGED IN . MAKE SURE THE CABLE IS PLUGGED INTO THE RECEPTACLE PROPERLY. (FIG. 22)

B. RAISE THE PALLET TABLE AND ADJUST THE F/B COMMUNICATOR BRACKET SWITCH UP A LITTLE . (FIG. 23)

C. CHECK THAT ALL 3 WIRES ARE FIRMLY ATTACHED TO THE F/B COMMUNICATOR BRACKET SWITCH. (FIG. 24)

D. CHECK THE CONDITION OF THE FLASHBACK CABLE. REPLACE THE CABLE IF YOU SEE ANY NICKS, CUTS OR ANY OTHER DAMAGE.

E. IF MORE THAN ONE FLASHBACK IS ON THE PRESS, CHECK ALL CABLE CONNECTIONS BETWEEN FLASHBACKS.

F. CALL TUF PRODUCTS SERVICE DEPT. FOR FURTHER INSTRUCTIONS.