EconoRed I conveyor dryers are compact productions dryers, making them an excellent choice for small-
to medium-sized shops. For energy efficiency, the new EC-I-54 has
dual heat zones. With a
54" wide belt you can run two rows of shirts. On shorter runs, shut
down a heat zone and run a single row of shirts to save you money!!
As of 2013, all EconoRed I dryers are also equipped with an
Exhaust System that cools the outer cabinet while evacuating moisture
and fumes; and a Digital Readout that displays DC volts, allowing you to
accurately repeat or fine-tune drying results at any future time.
*Rated Shirts/hr are approximations and are based on certain conditions including humidity, image size, substrate material, etc.
Electric: 240V / 37A / 1 Phase / 3 wire 50/60HZ (3 wire = 2 hot - 1 ground)
*** Wire and plug not included. Terminal block provided for on-site
electrical hookup. Must adhere to local regulations. Consult licensed
electrician. ***
Production: 380+ Plastisol Shirts/Hour*
Belt Width: 54"
Belt Speed: 1-12 FPM
Overall Dimensions:
(L x W x H) 66" x 67" x 46"
Chamber Length: 20"
Chamber In-Feed Width: 58.5"
Chamber In-Feed Height: 2" - 7" (adjustable)
Heater Dimensions: (2) 18" x 24"
Heater Wattage: 8,600 watts (2 x 4,300)
- Extra wide 54" belt allows for "All-Over" Prints to cure in single pass
- "X-Series" Conveyor Belt Tracking System with 30" wide PTFE coated belt
- Infrared Focusing System: 2" - 7" belt-to-heater clearance, adjustable separately on each side for each heater
- DC belt speed motor with digital voltage display
- Digital PID Temperature controller is accurate to +/-1°F
- 3 Year Defect Warranty
- 15 Year Heater Warranty
Optional:
- Belt Extensions (18" or 36")
- Scrub Air (forced hot air) — ideal for delicate materials
(Additional Electric: 120V or 240V, 1A - with grounded plug) - Wheel set with locking casters for easy mobility
- Hat Support Rail
Call
(800) 621-4173 for more information regarding additional options and heating chambers. Such
as an exhaust hood, low friction belt aligner
(recommended for longer conveyor belts), and heavy duty belt motor (also recommended for longer conveyor belts).
*Rated Shirts/hr are approximations and are based on certain conditions including humidity, image size, substrate material, etc.
What is the Infrared Focusing System?
Infrared emitters have an optimal distance at
which they operate most efficiently. If the emitter is too far away
energy is wasted and lost in the distance. If the emitter
is too close the substrate may come in contact with the emitter
surface. Adjusting the heater height is an absolute necessity if the
products that you print vary in height. We want to maintain an
approximate distance of 2 1/2" from heater surface to ink.